LMCP panel w/24-relay max capacity

Thank you for your interest in our products. To find the local representative in your area, please visit the "Where to Buy" link on our website. Our representative will be able to evaluate your needs and recommend the proper products to update your system.

No, the LMCP Panel is not DMX capable.

Yes, there are troubleshooting procedures available for the LMCP24 system. These procedures are outlined in the user manuals and include steps for common issues such as: 1. Checking Connections: Ensuring all wiring connections are secure and correctly installed. 2. Relay Functionality: Verifying that the relays are functioning properly and responding to control signals. 3. Sensor Inputs: Checking that inputs from switches, occupancy sensors, and daylight sensors are properly connected and operational. 4. System Reset: Performing a system reset or cycling power to the panel to clear any temporary faults. 5. Software Updates: Ensuring that the system software and firmware are up to date. For detailed troubleshooting steps, you can refer to the user manuals available on the Legrand website. These manuals provide comprehensive guidance on installation, configuration, and troubleshooting for the LMCP series panels. In addition to the written troubleshooting procedures available on the Legrand website, there are also instructional videos on YouTube. By searching for "Wattstopper LMCP" on YouTube, you can find various videos that provide visual guides and step-by-step instructions for troubleshooting and maintaining your LMCP24 lighting control panels. These videos can be particularly helpful for visual learners or for seeing practical demonstrations of the troubleshooting steps. Lastly, you can also call Technical Support at 1-800-879-8585 Option 3.

This specific panel does not have dimming capability on its own, but the LMCP 0-10V PANEL will allow for 0-10v dimming without additional controls. The LMDM switch is recommended to go with the panel but there are other options available in the DLM family. Please contact your local Wattstopper Rep for more information.

You do not need a relay per fixture, you need a relay per circuit per zone. 1 zone with1 normal circuit and 1 EM circuit would only need 1 HDR and 1 EM relay; or one relay and an ELCU.

Yes, you can group 48 loads into one group.

The LMCP-48 does not have an app for its controls. You can however access the programming with a LMCT-100-2 handheld remote or with LMCS-100 software installed on a laptop (using an LMCI-100 dongle for the connection). Please contact Wattstopper Technical Support @ 800-879-8585 if you need further assistance.