PIR Wall Switch Occupancy Sensor

Unfortunately, Wattstopper does not sell replacement button covers.

Greetings Joel, Both devices are recommended to have constant power, and typically installed as standalone devices. We suggest DLM if we are needing additional coverage in the space.

You can include up to 4 PW-301's in a multi-way configuration. Simply add switches to the wiring diagram shown in the installation instructions which can be found at the following URL: https://www.legrand.us/lighting-controls-and-systems/occupancy-and-vacancy-sensors/wall-switch-occupancy-and-vacancy-sensors/pir-wall-switch-occupancy-sensor-white/p/pw-301-w The additional switches would be added in a similar fashion to the leftmost switcch in the wiring diagram, with the load wires capped off on all but one of the switches, which is connected to the load.

Yes, the PW-301 is the direct replacement for the PW-101.

Jamie, The Wattstopper Low voltage versions can, i.e. DW-100-24 sensor switch can be wired in parallel to a DT-300 ceiling sensor.

Hello, The PW301 supports Multi-Way capability. Sensors can easily be wired together for convenient control of a common load. When wiring this way, only use 300 series sensors. Multi-Way in 300 series is not compatible with prior sensor models. Best Regards, Technical Support

Hi Sione, Please see chart below for dipswitch settings for your sensor. 30 mins = 1/2/3 on/on/off and 8/9 both off to enable auto on feature.

Hello Bryan10, PW301R will support LED fixtures. Best Regards, Technical Support