Wiremold AL3300 Series Raceway Base

Hello. The AL3300 series raceway is 2-7/8" wide by 1-7/8" deep. The standard finish is satin anodized aluminum. Brass is not a standard option. Other color finishes / paints may be available as a customization option. Thanks!

Hi William, I apologize about the delayed response. Legrand Wiremold surface metal raceways and fittings are cULus listed (RJBT/RJBT7.E4376, RJPR/RJPR7.E41751) and have been tested and evaluated to UL 5 - the Standard for Surface Metal Raceways and Fittings and CSA C22.2 No. 62 – Surface Raceway Systems. The installation of surface metal raceway and fittings shall comply with all the requirements of Article 386 of the NEC. Per Article 386.12(2) and UL 5, raceways constructed entirely of metal at least 0.040 inches nominal may house circuits operating at potentials not exceeding 600 volts between conductors. Metal raceways constructed with metal thinner than 0.040 inches nominal are limited to housing circuits operating at potentials not exceeding 300 volts between conductors. It is important to ensure that the surface metal raceway selected is rated to accommodate the operating voltage of the conductors being installed. Article 760.46 and 760.130 of the NEC specifically point to Chapter 3 for wiring method requirements. Surface metal raceway installed in compliance with Article 386 is an acceptable wiring method for non-power limited and power-limited fire alarm circuit wiring. If you need any additional information, or have additional questions please feel free to reach out to us directly via email at technical.support@legrand.us or by phone at 1-844-957-3783, option 2 for Wiremold, followed by option 2 again for Wiremold tech support. Thank you,

Hi Steve, Our raceways are for interior dry locations only, unfortunately there are no outdoor rated raceways that we offer. Thank you for checking with us.