400 Internal Elbow Fitting

400 Series Internal Elbow. For right angle turns around internal corners.

Send
Save as PDF
Added to Favorites Go to favorites

Remove from favorites?

Something went wrong. Please try again later.

Features

General Info

Product Line	Wiremold
UPC Number	786776052046
Country Of Origin	United States
Standard	cULus Listed Raceway: File E90378 Guide RJTX. Complies with flammability rewuirements of UL-5A. Fittings: File E90377 Guide RJYT. Meets Article 388 of NEC. UL Listed for up to 600V. Meets Section 12-2600 of CEC.
Type	Raceway

Dimensions

Product Width US	1.5 in
Product Length US	1.5 in

Additional Information

RoHS Compliant	Yes		This product meets the material restrictions of Article 4 of the RoHS Directive (2011/65/EU), including Commission Delegated Directive 2015/863.
Product Environmental Profile	Yes

Listing Agencies / 3rd Party Agencies

cULus ListingNumber	E90377
cULus Listed	Yes

Buy American Act Compliance

NAFTA

Yes

Technical Information

Voltage

600.0 V

Resources

For inside corner of series 400 NM raceway, do I miter the ends of both channels and covers and mount them to make a 90 degree joint before snapping a 400 Internal Elbow Fitting over them or cut the channels and covers to stop at the ends of the elbow

Asked by: Denis

Good Afternoon- You would cut the base and cover which will then go into the internal elbow (417). We also offer a 90 degree flat elbow (411).

Answered by: Wiremold Tech Support

Date published: 2021-05-25